The Q7 and Q8 look particularly massive when stationary – a low position completely changes their appearance. DropIT! V1 automatically lowers the standard air suspension via OBD, without any wiring or permanent coding.
Select Q7/SQ7 variant Select Q8/SQ8/RS Q8 variant
Supported Audi SUV Models
- Audi Q7 and SQ7 4M
- Audi Q8, SQ8 and RS Q8 4M
Your vehicle must be equipped with the standard air suspension ex-works. Q7 and Q8 use different DropIT! variants, which you select directly on the product page.
Check SFD2/UNECE for Q7 and Q8
Vehicles up to early 2023 are generally compatible without SFD2 inspection. Model year 2024 and some vehicles from mid-2023 may have the new diagnostic protection.
- NI0: uncritical according to current status
- NI1, NI7, NI8 or NI9: clarify compatibility before purchase
- Diagnostic message "SFD2" or "UNECE": not compatible
You can usually find the PR code in the service booklet or on the vehicle data carrier. If unsure, inquire before ordering.
Lowering without installation on the chassis
In contrast to permanently installed control units or solutions on height sensors, DropIT! V1 is only connected to the OBD interface. The automatic sequence first lowers the front axle and then the rear axle.
The brake is not needed for this. A short tap on the brake serves exclusively as an optional stop for the active axle.
Ideal for meetings and vehicle photography
- Significantly lower stance
- No app and no additional coding software
- No permanent installation
- Can be removed without leaving any residue
- Original chassis control remains unchanged
Frequently Asked Questions about Q7/Q8 4M
Is DropIT! also suitable for SQ7 and RS Q8?
Yes. There is a Q7/SQ7 variant and a Q8/SQ8/RS-Q8 variant. Prerequisites are the original air suspension and a successful SFD2 check.
Does anything need to be mounted on the underbody?
No. DropIT! V1 works via the OBD interface and does not require any cables to height sensors or control units.
Can I remove the module again?
Yes. DropIT! V1 is not permanently installed and can be removed without leaving any residue.